Results 1 to 2 of 2

Thread: Lots of Carbed 1989 Accord Parts

  1. #1
    DX User Shilo's Avatar
    Join Date
    Jul 2010
    Vehicle
    1989 Accord LX, 1976 Nova, 1980 Plymouth TC3, 1985 AMC Eagle
    Location
    Virginia
    Posts
    78

    Lots of Carbed 1989 Accord Parts

    I'm converting my 1989 LX to EFI and I could use a little extra cash, so I will be selling everything I don't need. All prices do not include shipping (PM me zip code for estimate, I'm willing ship international as well), and all prices are NOT firm and all offers are welcome. I have some other stuff I will be posting up later as well so check back later or PM me if you need anything special.

    All parts were pulled off my 1989 Accord LX 5spd and all should fit 88 to 89 with no problems and may fit 86 and 87 as well (please check before buying as I know there are some differences between the years).

    Carburetor $100 (should fit in USPS flat rate box so shipping will be cheap): In VERY good condition and looks to have either been replaced or rebuilt not long ago (odometer reads 178k and I doubt it has been on there that long). Car ran strong, but would sometimes stumble and shut off when idling or coming to a stop. When I removed it I found that the throttle cable was very lose, and a few broken vacuum lines as well. This carb should be ready to bolt on and go.








    Intake Manifold $50: Very good condition with no cracks. Includes EGR valve and carb bore heater.






    Exhaust Manifold $45: Good condition with minor surface rust. One of the bolts for the mounting bracket is broken off (wasn't bolted to bracket when I got the car and had no problems with it, but I'm sure it wouldn't be hard to remove it or drill out and re tap it). There is also a small hole on the opossite side of one of the studs, but does not hurt anything. Heat shield had a few holes in it, but I can include it if you want it for no extra charge. Includes O2 sensor.








    Down pipe with flex connector $75: This is practically brand new and was installed on the car and only ran for a few minutes. I bought this with my new exhaust before I knew I was converting to EFI, so I can not use this anymore. I paid $100 including shipping for it.




    Engine Wiring Harness $35: All clips are in good condition and it has never been cut or molested in any way.




  2. #2
    DX User Shilo's Avatar
    Join Date
    Jul 2010
    Vehicle
    1989 Accord LX, 1976 Nova, 1980 Plymouth TC3, 1985 AMC Eagle
    Location
    Virginia
    Posts
    78

    Re: Lots of Carbed 1989 Accord Parts

    Distributor $40: Good condition and includes vacuum advance and cap.




    Alternator $25: Good unit, charges fine, and includes pulley.




    Cruise Control Servo $10: Looks to be in good shape, but I never tested it. I would be surprised if it didn't work.




    All prices are based on what some of my local junkyards have listed and are significantly lower. Like I said before I welcome all offers, but don't expect me to give this stuff away .
    Last edited by Shilo; 08-09-2010 at 01:56 PM.

Similar Threads

  1. 1989 Accord with lots of goodies
    By frantik in forum For Sale
    Replies: 5
    Last Post: 03-05-2012, 01:15 PM
  2. 89 Accord Lxi mtx lots of new parts Delta 272
    By RobDirt89 in forum For Sale
    Replies: 0
    Last Post: 11-18-2011, 10:37 AM
  3. Replies: 8
    Last Post: 10-20-2007, 04:25 PM

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.
     
Links monetized by VigLink