JDM Corners on Euro Sedan

[a1meat]

hello there,

i´ve just received some jdm corner lights to put on my 89 sedan.

The housing of the JDM´s appears to be larger then the EDM one.

The original part:

By a1meat at 2011-03-13

JDM:

By a1meat at 2011-03-13

Is there anybody who did this before ? someone to give me an advice on how to make it fit better....
It just doesn´t fit as tight as the original corner and goes deeper to the bumper.


By a1meat at 2011-03-13

[dacantu]

You probably needed to get the JDM bracket also. Besides that they should be the same unless they were from a different year.

[Nafs Asdf]

I have a spare pair of JDM corners so I just dug em up and compared them to my old euro corners. Only difference I could see was the two tabs at the front of the JDM corners were slightly longer.

Can't remember if mine sat differently when I put them on, I might check that tomorrow when it's light.

[Nafs Asdf]

You probably needed to get the JDM bracket also. Besides that they should be the same unless they were from a different year.

Euro corners are the same for all years, and I think the JDM are too. Only difference is I think 86-87 JDM got all amber ones.

[a1meat]

here is some more pics....

@Nafs Asdf: have you already checked the corners on your redOne?


By a1meat at 2011-03-15


By a1meat at 2011-03-15


By a1meat at 2011-03-15

[A18A]

are they clipped in properly? they don't appear to be

[charliekuney]

^ The seal also looks unattached.

[A18A]

on the subject of imperfections, the bonnet needs to be slightly raised on the passenger side :P

[Nafs Asdf]

I haven't gotten the chance to check mine up close yet, been busy. I'll try to do it today. I think A18A is right tho, seems like yours aren't just seated properly.

[a1meat]

didn´t find a solution to make them fit as clean as i´d imagine.

if anybody wants the corners, just let me know...

[Nafs Asdf]

I keep forgetting to check mine, sorry