new 3g carb help

[bryan42688]

Hey guys I'm a Honda freak just picked up a 3g a20a1 automatic, im looking for the emission removal guide that I used for my 87 link I found was dead , also I'm wondering the process of a manual swap I would do both motor and trans at the same time but want to know is it hard to do final question is if I did a b20 swap wouldn't I need the ecu , seller is not including it , main thing I want though is vacuum removal guide please

[2oodoor]

https://www.3geez.com/forum/showthread.php?t=11067 here is your link

You can use the carbed intake with carb on the B20A, you will need a first gen integra distributor, plugs right in.

https://www.3geez.com/forum/showthrea...t=65644&page=4 my project

https://www.3geez.com/forum/showthrea...light=egrodomy
another interesting project if you want to really eliminate all the unsightleys

[bryan42688]

Thanks a million I found it and did it now in park I idle only at 2250 and drive 1250 I feel like I've read about this before any suggestions

[2oodoor]

That is too high rpm for both of those conditions, it should be more like 1200 at idle in park, 8-900 in drive

[bryan42688]

Any suggestions

[bryan42688]

Got it the check valve for idle diaphragm was backwards I would have thoyght air went into the carb

[bryan42688]

Got it the check valve for idle diaphragm was backwards I would have thoyght air went into the carb

[A20A1]

Where did you connect the check valve to? The Idle Diaphragm line should go to the manifold not the carb.

*Vacuum is misspelled on one of the frames.