B20a Head Gasket

[RCracer]

Has anyone got a photo of a honda head gasket for a B20a?

I dont want a drawing of the gasket (I have a few drawings. from gasket books etc) I want a photo to compare to the gasket I got today. Some of the coolant holes dont seem to line up and there are a couple of water-ways that are totally covered by the gasket.
I have the gasket from my B20a and a gasket from a blown B20a that I bought, both are slightly differant and both are slightly differant from the one I got today.
It is the only gasket that is listed for the B20a, B20a2, B20a7 engines.

If you have a photo and cant post it email it to me @

[email protected]

Thanks

(I would have attached a photo of my head gasket but the digital camera doesn't want to play for some reason today :angry: )

[YK86]

I will get a photo of my old one along with all the other info you wanted some time tomorrow. I have to recharge my batteries for my digital camera.

[YK86]

Here's a pic. Since it's used, it has marks from the coolant passages and stuff making it hard to see the holes so I filled them in to avoid any confusion. If you want the original photo without the filled in holes, I post those too. I'll get the torque specs for you tommorrow.

[smufguy]

the bore looks bigger than the A20, is it a lil bigger?

[YK86]

The B20A is actually smaller. It's 81mm compared to the A20's 82.7mm.