10" subs under $50 each

[smufguy]

I wanna know what kinda Subs (10") that are decent. like this http://shopping.yahoo.com/shop?d=zcs...ice&sortOrder=

I saw twin Alpines and damn those base. I dont wanna go to 12" due to the loss of my most desired base in em. Well everyone seems to have their own opinion, but i will stick with m 10". So anywayz, anything good under that budget? thanks guys I need two of them and also a box for those badboys. where can i get em? thanks again. :super:

[smufguy]

http://www.millionbuy.com/caudio-woofbox-dualwoof.html this is what i found out searching for enclousers. Are these decent prices? to me it sounds fine compared to all the shit in the stores here in NJ.

[smufguy]

are NTX subs good?

[smufguy]

also i need a decent 2 channel amp to drvie them not too expensive, but decent ones for the money. Thanks again.

[shepherd79]

here is alpine http://www.savinglots.com/lotprod.asp?item=SWS1041 it is a little over your budget.
here are nice looking subs, http://www.savinglots.com/lotprod.asp?item=BL-10
http://www.savinglots.com/lotprod.asp?item=T9010
this ones look very nice may want to consider them http://www.savinglots.com/lotprod.asp?item=ELF10
or this ones http://www.savinglots.com/lotprod.asp?item=AW1051Q

here are some packages http://www.savinglots.com/caraudio3....osed%20Woofers
or empty enclosures http://www.savinglots.com/caraudio3....y%20Enclosures
and here are the amps http://www.savinglots.com/caramplifiers.asp

just look around this store. i think they have great prices and shipping is great too. i bought from them a few thing. they have very fast shipping.
if you wanna talk more about it. IM me. i should be online.

[smufguy]

Are These Boxes good?

http://shop.store.yahoo.com/discave/sq10dualcars.html

http://www.millionbuy.com/hbx10ej.html

How are the Mobile Authority Subs and Lightning Audio or Pyramid? I loveeeeeeeeeeeeeeeeeeee the deep base on the Alpine from the store i was like yeah baby that is the shit. cause even MTX did not come close to the base that Alpine had. So do i get enough base from those subs? I have no clue how they are cause i dont see them around here in stores.

[smufguy]

http://www.millionbuy.com/lib/millionbuy/amplifier.htm

This site actually has everything on free shipping so u know, even with other sites, i get like cheaper, but the shipping costs come upto like 15 bucks.

[shepherd79]

how much do you want to spend on the amp?
well, you will get what you pay for. this is what i have been saying all my life. It is true in a lot of cases.
i think you should save a little more and get something good.
http://www.millionbuy.com/apnsws1041d.html
http://www.millionbuy.com/apnswe1041.html with 200rms power you should be good.
i like this one http://www.millionbuy.com/pericbm5710.html
i heard this ones they have nice and tight bass http://www.millionbuy.com/vofzx4710.html
you can never go wrong with Rockford Fosgate http://www.millionbuy.com/rocrfz3410.html
i guess it all depends how much you want to spend. and what power lever are you looking. if you want to spend $50 per sub, i am thinking you will get around 200-300W per sub, power level handling.
about the boxes. they should be the same. make sure you know the dimensions to calculate the volume. WxHxD=volume for square box. I would say try to get a box with back sloped.
if you get square box the waves that will travel inside the box will bounce from the back and hit the sub and cancel out. this will decrease sound performance. if you have back or front sloped the sound wave will bounce all around and you should hear nice bass.
anyway, i think you should save more money and get something nice, this way you are gonna know that you some quality shit.

[smufguy]

Wow, u know what I am either gonna go with Alpines or Rockford Fosgate though Volfenhag ZX-4710 seems really tempting. I know what i am gonan get now. hehehehe, thanks for the headsup on the box man. u were such a help. Thanks soooo much bro. i am gonna save up a lot for this. Thanks a lot. And thanks to everyone who pitched in to help me out.

[shepherd79]

no problem man.
keep us updated.

[1989se-i]

i want wolfevnbhjdhgkd-hags

[shepherd79]

yeah i know, i think if i build my next system that Volfenhag is what i am gonna go with. just look at their amp prices they are cheap but they putt out a lot of power. i am sure it is true power too.

[smufguy]

are they trust worthy company though?

[smufguy]

what u think about that box man. just in case it wont work, here is the link to it http://www.millionbuy.com/hbxdc10.html.

[smufguy]

okay this is the ordeal. The Volfenhag subs are 2-4, 8 ohm operation. so that basically means i can use a 2channel amp that would run with either a 2 ohm, or a 4 ohm, or even a 8 ohm right? Lower the number (2) deeper the base right?

[smufguy]

BLAUPUNKT PCWI1000
Product Features:


For use in free-air, sealed, vented and band-pass enclosures
Power handling: 540W max./180W RMS
Frequency response: 20 Hz-2,000Hz
Sensibility:92dB (2.83V/1m) 89dB(1W/1m)
Thiele/small parameters:fs=25Hz
4 ohm system impedance
Woofer magnet weight:40oz
VFP Vacuum Formed Poly cones retain their rigid shape regardless of listening conditions.
High excursion treated foam surrounds
HUGE magnet assemblies with extended pole designs for tremendous power handling
HUGE voice coils for maximum heat dissipation
Multi-box Qts values allow for sealed, vented, and band-pass box designs as well as moderately power infinite baffle installs.
5-way binding posts for multiple wiring systems. Protective rubberized magnet cap housing





Infinity 1020W
Product Features:


Single woofer
Dual stacked magnets and bump backplate increase efficiency and provide additional clearance for long Xmax.
Hi-Roll Rubber Surrounds offer superior cone edge suspension and reject moisture and UV.
A wopping 11.9 millimeter X-max delivers serious excurion. This subwoofers is great for high SPL and sound quality applications.
Check out the downloadable and viewable Box and Parameter Sheet for additional info and suggested enclosures.
Nominal Impedance: 4 ohms
Power Handling: 250WRMS/1000W Peak
Sensivity 2.83V/1m: 90dB
Frequency Response: 22Hz - 800 Hz
Mounting Depth: 5-1/2" (140mm)
Cut-out Diameter: 9-1/4" (235mm)
Power Handling RMS: 250W
Power Handling Peak: 1000W
Sensitivity: 90dB
Frequency Response (± 3dB): 22Hz - 800Hz
Mounting Depth: 5-1/2"
Impedance: 4 Ohms




Pioneer TS-W254DVC
Product Features:
10" Foamed IMPP (Injection Molded Polypropylene) Rigilite
Composite Cone Woofer
Dual-Layer Urethane Surround
Direct Bobbin Mounted VCCS (Voice Coil Cooling System)
Conex Damper with Damper Ring
Lead Wires Integrated into Damper for High Reliability and Improved Power Transfer
Projected Pole Yoke with Vented Pole
High-Energy Ferrite Magnet with Bumped Back Plate
Low-Q Design for use in Small Sealed Box (0.8 cubic foot recommended)
Dual Voice Coil (2x4ohm) Design for Increased System Flexibility
Specifications
500 Watts Max Music Power
250 Watts Nominal Power Handling
Frequency Response: 18-2,500Hz
Sensitivity (Efficiency): 87dB (1W/1m)
2 ohm or 8ohm Rated

[smufguy]

these are the subs with a really low pick up freq so far. Which as u know, leads to deeper base. what u guys think of these 3 subs? Good for the deal, which one do u guys think would be the best fot the money u spend. considering ur not a rich bastard

[smufguy]

Specifications:
Thick construction : 3/4"
Color:Black
Terminal Placement: Rear (2)
PLGA Glass: 29" x 11 3/4"
Dimensions (WxHxD): 30" x 13" x 16 x 11 1/2" (side depth)
SQ Hole:6 5/8" x 3 1/2"
Weight : 34.4 lbs
Tunable port : 1 SQ




Specifications:
Thick construction : 3/4"
Tunable Ports : 4
Color:Black
Terminal Placement: Rear (2)
Plexi-glass size : 23 5/8" x 11 1/2"
Port Hole Size: 2 1/2"
Dimensions (WxHxDXTD): 25" x 13" x 13 1/2" x 11" (side depth)
Weight : 26.6 lbs


WHICH ONE IS A BETTER BOX FOR THE SOUND? THE PRICES ARE AROUND THE SAME AREA SO ITS NOT AN ISSUE. THANKS ONCE AGAIN.

[shepherd79]

Nice subs. i would go with pioneer or infinity. they both can handle 250RMS. which means you can run them on 400-500Rms amp easy.
about the boxes. are you sure you want ported box. everyone recomend sealed. i have sealed and it is nice.
i think you should go with sealed.

[shepherd79]

you may want to check with your local stereo shop about the boxes.

[smufguy]

I am gonna get these Pioneer ones and what kinda amp do u recommend if i get two of these Pioneers? Is it better to get just one 2 channel or 2 mono?

Whats the difference bwt Ported and Sealed? Are they different in a Bandpass and an open?

[shepherd79]

i asked the question about the box types before and this is what i got in responce https://www.3geez.com/showthread.php?s=&threadid=7118 i hope that explains. i am gonna stick with sealed box. when i got my alpine my local stereo shop used sealed box. I love the sound of it. i think it is bery clear bass.
ok about the amp, those pioneer can hold 250W a piece, which makes 500 for both of them. if i was you i would get an amp that can push at least 400Watt in RMS. which one to get, 2ch or mono, it is all depends how are you gonna wire them. most people bridge their amps to get more power with makes 2channel a mono amp. so it is up to you how are you gonna wire the subs to the amp.
this one is not bad http://www.millionbuy.com/prfcl600m.html
this is what people have to say about profile amp, this one is 4 channel http://www.epinions.com/Profile_CL640_626404 but read the review.
you could go with this one http://www.millionbuy.com/piogmx962.html but in my opinion it is overpriced for it is power.
i just read on internet to stay away from Volfenhag. they made cheaply and can't hold much power. http://www.clubknowledge.com/cgi-loc...ction.cgi?g637
this is the link if you want to read it.

ok back to the amps, this one is not bad http://www.millionbuy.com/kenkac729s.html
Profile is good for a beginers but if you want something that can last longer go with something else.
i would guess that your best bet would be to go on ebay and look around.
i will see what i can find on ebay for a nice price
range under $100-150. i got my alpine mono amp for $150, but it is only pushing like 150W at 4ohm load, or 200watt at 2ohm load.
let me look on ebay and see what i can find.

[smufguy]

Volfenhag ZX-7140
High power 500 watts MAX 2 x 250 w @ 2 OHM
2 OHM stable
Tri mode capable 1 or 2 channel
Fan cooling system
Variable bass boost 0 to 18dB
Variable bass crossover frequency 30 to 100 Hz
Signal to noise ratio 97dB
THD 0.03%
Frequency response 20Hz to 20KHz
High and low level inputs
282mm x 59mm x 231mm


HOw does that sound? are these good bro?

[87AccordsterLx]

wooohooo... I have those exact pioneers in 12's with a sealed custom fosgate box... I read what you said shepherd about the boxes that have flat backs to them.... damn mine has a flat back.... I wonder if my shit would sound better with it slanted.... its really nice right now and I have a 400w Interfire amp rated 450w... It pushes those pioneers great... I still want a more powerful amp though... If I were you Praveen I would go with Fosgate, memphis, or Alpine... if you go Alpine you should go with a powerful one... well you should go with a powerful one regardless but if you go go with anything thats rated under 450 watts your going to find yourself wanting more power in like 2-3 months... Thats just my opinion though.... 200w per sub doesnt feel like much... it pushes a lot of air having 2 12's thats for damn sure but I would love to double my amps wattage with a 800w 2way Fosgate and push 400 per sub... That Volfenhag looks good... if it really pushes 500w then I would say go for it... it looks like it vents well too.... just remember to bridge it and see how it sounds if you run the subs in parellel....

[87AccordsterLx]

oh crap Im sorry... I think mine support 600w max... it may be because they are 12's or maybe they are just a lil bit different...