Such a random sizing interval. Crankcase end of the hose is like almost an inch ID and ¼ inch ID at the intake.
Has anyone had to recently replace theirs and how'd you do it?
I used random hose adapters and hoses.
Sent from My Samsung Galaxy Prevail
Shaggy
FF II/ETC I
"What's my age again? What's my age again?"
Curious about this too. Mine is split in half.
I use a formed heater bypass hose from an 80's Mopar 318, trim off the Honda plastic piece as much as it can stand and it can be used with that but if not, there are other ways to reduce it to fit the valve. The Mopar hose fits the oil separator perfectly and bends a 90 with 1" ID
Last edited by 2oodoor; 07-23-2013 at 04:10 PM.
if you are referring to number 3 in the pic below it is the breather tube.Originally Posted by firefighterwhite89
THe breather tube can be ordered from any Honda dealer. Online it can be ordered from Honda Parts at Honda Parts Now | Genuine OEM Honda Auto Parts or Discount Auto Parts Online -- PartsGeek.com - Domestic & Import Auto Parts Warehouse. I replace one on my 86 DX (R.I.P) and one on my 89 LXi. It is 22MM ID. When it needs to be replaced it is as hard as plastic but it is rubber. After you cut the old one out, the new one is hard to install because you need to fold it to get it on both the oil pan and the breather chamber.
No. Talking about #5 on your picture. Number 3 would have been a cake solution. The ridiculous hose interchange, in such a tiny length....
Sent from My Samsung Galaxy Prevail
Shaggy
FF II/ETC I
"What's my age again? What's my age again?"
#6 isn't it ?
#6 looks like it's for carbs, #5 for EFI. Yeah, that's the most retarded, unreplacable tube I've ever seen. What the hell am I supposed to do with that?
When I replaced mine I replaced all the other hoses as well. I changed out the breather chamber grommet and o ring as well. I'm pretty sure I removed the breather chamber, installed the new o ring and grommet on it, attatched the new hose to the oil filter, and the one that goes to the PCV valve then put the entire assembly (chamber both hoses, and new o ring) back in and then got the top of the tube to slide in place
Using the Dodge hose brings the end out and over to the right of the intake manifold where you can get to it, you can always use a valve set up using regular hose stock, clamps and grommets..I do use a clamp to hold that hose to the oil box, it fits but kinda loose feeling when I am working with it.
Last edited by 2oodoor; 07-26-2013 at 04:21 AM.
This was my nightmare but it all worked out. https://www.3geez.com/forum/efi-tech/...ve-88-lxi.html
My '66' GT I built. My first Hot Rod magazine Cover "Summer 85". I've had it for 32 years, since I was 18. It's a trailer queen. 289 Hi-po, t-10 Toploader 4speed, 9 inch rearend.
#5 may not be available for the 86 but it is for the 89. It looks like it was changed in 88.
Honda Parts at Honda Parts Now | Genuine OEM Honda Auto Parts has the 88-89 version for about $15.00 it might be worth trying it.
The part number is 11855-PH3-J01
Part Detail
thanks for the reference. here in a few weeks, i'll probably order this and we'll see how it goes.
Shaggy
FF II/ETC I
"What's my age again? What's my age again?"
Posting Permissions
Reply With Quote
Bookmarks