how hard is it to build a custom box? not a whole box but just to make a custom installation under my back seats, i wanna put an amp in the middle and 2 type r subs under each seat...is it rocket sciense to do it? has any1 done something similar? i wanna save some cash by doin it on my own. what materials might i need? any info wood be appreciated
some1 plz help
you have a gas tank up under there, just like your old accord, so you really can't cut anything, and you have to have padding on the seats...one thing you can do is seal your trunk, cut holes in the backs of your rear seats, use those waffle grilles, and put them in there... this give the effect of one huge box, and no worries of the box itself
Derick
If you want to make a box, the wood you would want to use is MDF. I think it means Medium Density Fiberboard. You would want to use 3/4 inch width. You would need some wood glue and some drywall screws. Most likely a drill bit to pre drill the holes so the screws dont split the wood. A circular or table saw, and a jig saw to cut the hole for the sub, or for ports. Thats about it.
I guess I'm a little confused. It isn't possible to fit any thing under the rear seats is it. There isn't any space under them. I can under stand if it was a truck or some thing that has open space under the rear seat, but I don't see how you plan on doing this with our cars. I have done a custom install in a dodge extended cab so i do know how to do it, but it just doesn't sound possible with our cars without pemanently removing the rear seats or something.
Check out the install in the dodge.
Peace out
89 Lx-i
Performance: K&N filter,custom CAI, Accel coil, MSD 6aL ignition, magnecor wires, high flow injectors, FPR, sport exhaust,Tokico springs/struts
Appearance: white gauges, side markers, headlight conversion, clear bumper signal/fog light conversion, SE-i center armrest and cupholder, SE-i leather seats
17" ADRs with 205/40/17 khumos
future plans: 16" or 17" rims(can scratch that one off the list 9-12-02), headers-high flow cat.-cat back piping. Rear disc brakes from SE-i, reground cam.
Originally posted by 89accordlxi
I guess I'm a little confused. It isn't possible to fit any thing under the rear seats is it. There isn't any space under them. I can under stand if it was a truck or some thing that has open space under the rear seat, but I don't see how you plan on doing this with our cars. I have done a custom install in a dodge extended cab so i do know how to do it, but it just doesn't sound possible with our cars without pemanently removing the rear seats or something.
Check out the install in the dodge.
Peace out
my cars a teg:p
Sorry, my bad. I guess I would have to see what a teg looks like before I can make any suggestions. Good luck.
i'm out.
89 Lx-i
Performance: K&N filter,custom CAI, Accel coil, MSD 6aL ignition, magnecor wires, high flow injectors, FPR, sport exhaust,Tokico springs/struts
Appearance: white gauges, side markers, headlight conversion, clear bumper signal/fog light conversion, SE-i center armrest and cupholder, SE-i leather seats
17" ADRs with 205/40/17 khumos
future plans: 16" or 17" rims(can scratch that one off the list 9-12-02), headers-high flow cat.-cat back piping. Rear disc brakes from SE-i, reground cam.
Posting Permissions
Reply With Quote
Bookmarks