does any body have a pic of a speedmeter clip where it connects to the tranny !
thanx !
MIKE
does any body have a pic of a speedmeter clip where it connects to the tranny !
thanx !
MIKE
3geez member since October 4th 2001
u mean the clip that connects the speedo cable? its amazing u got questions
yeah, its probably the speedo cable is loose in the tranny. check to see if u see a 'C' clip once u move the rubber gourmet from it. If its fixed and still bounces around. Then u need to replace the speed sensor and its not that hard to get one from the junk and put it in u car.
you have posted this in another thread !
that's the clip i mean !
i need the pic of the clip so i can get a similar one !
because when i removed the rubber i realized that i don't have a clip ! and my speedmeter bounces !
MIKE
3geez member since October 4th 2001
...^
..( )
.O O
Eh, looks something like that
Last edited by BoredRec; 11-17-2002 at 11:24 AM.
1988 Accord LXi Sedan
Custom Cold Air Intake -- Custom Exhaust -- Neuspeed Springs -- ACT Stage II Clutch
Alpine 9815 -- MTX 2300X -- 2 JL 10W3V2's
thats a wrecker item - thats what i'd do
89 efi conversion
17" katana, lude arms, full 2" exhaust/hollowed cat, Ractive intake, centerforce dual friction, msd coil/wires
yeah but i need a picture to know what it looks like !
please guys , can someone shoot it even if in place !
MIKE
3geez member since October 4th 2001
A bouncing speedo isn't related to the clip. It's because you need a new speedo cable.
http://pages.videotron.com/omus
3geez member since July 12 2000
I need these parts!
https://www.3geez.com/forum/showthread.php?t=67742
may be so ! but when i was checkin my cable at the tranny it's very loose i just pulled and it came right out !
so please guys !
MIKE
3geez member since October 4th 2001
Do they have Honda dealers in Egypt? I'd say just go buy one, they're only like a buck, if that. Sorry for no pics, don't have one handy, and I sure as hell don't wanna pull it off my car.
1988 Accord LXi Sedan
Custom Cold Air Intake -- Custom Exhaust -- Neuspeed Springs -- ACT Stage II Clutch
Alpine 9815 -- MTX 2300X -- 2 JL 10W3V2's
they don't work here with part numbers , you have to bring them the old part !
and i am not asking to tear your car a part but raise the boot on the end a little bit and shoot it ! pleeeeeease !
or is it available @ majestic honda ??
MIKE
3geez member since October 4th 2001
here is a pic can you tell me the number of that clip on the pic !
MIKE
3geez member since October 4th 2001
The part number is not there
You know what? you should brin them a GM part and ask for this!
What kind of dealership is that! They should also work with part numbers. did you file a complaint to Honda of Egypt?
The part you'Re looking for is the number 8 on that link
http://www.hondaautomotiveparts.com/...P-SPEED+SENSOR
They will rip you out of 87 cents....
http://pages.videotron.com/omus
3geez member since July 12 2000
I need these parts!
https://www.3geez.com/forum/showthread.php?t=67742
it would seem like 9 to me.
- Col Jack O'Neal - Stargate sg-1."If you were paying attention DANIEL you'd know the Nintendo's pass threw everything!"
errrrrr............. maybe......... NOT
I may be french canadian, but I do know that O-rings aren't used to retain cables
http://pages.videotron.com/omus
3geez member since July 12 2000
I need these parts!
https://www.3geez.com/forum/showthread.php?t=67742
hi carotman ! where 've you been !Originally posted by carotman
What kind of dealership is that! They should also work with part numbers. did you file a complaint to Honda of Egypt?
anyway HONDA egypt sucks big time !i think i'll file a complain to HONDA JAPAN !
thanx carotman for the link !
but how to install that clip ?
should it be under the boot or over it ! ?
sorry to bother you with so many question !
thanx again !
MIKE
3geez member since October 4th 2001
Under the boot, I never bother pulling the boot all the way down after that, it's just a nuisance.
1988 Accord LXi Sedan
Custom Cold Air Intake -- Custom Exhaust -- Neuspeed Springs -- ACT Stage II Clutch
Alpine 9815 -- MTX 2300X -- 2 JL 10W3V2's
i 'll try to get some photos to understand hwo can i attach it !
is it in Paul's online service manaul ! ?
MIKE
3geez member since October 4th 2001
i can take a pic of the clip...but i cant post on the site...email me and ill email back [email protected]
thanx man !
i'll sure will !
MIKE
3geez member since October 4th 2001
I found what ur looking for...
can you spare $.87?
here ya go
...and a pic... it's #8.
-Mark D.
I should prol'ly get one too...
...i have'nt had one in since I did my 5spd swap months ago... speedo's fine tho...lol....anyway..
-Mark D.
SHIT !! i forgot to mention !
MY speedo cable popped out of the tranny ! i put it on again and it keeps popping out ! even the boot doesn't hold it in place !
heeeeeeeeeeeeeelp !
MIKE
3geez member since October 4th 2001
ok so you better get a #1, and #8 now.
along with a #5
That should do the trick!
Last edited by markmdz89hatch; 11-23-2002 at 08:20 AM.
-Mark D.
accord_lx_86 just mailed me the pic of the clip ! but how the hell should i put it on !
i looked at the wire and here is a pic of it !
# 1 is the wire it self
# 2 is a groove
# 3 is a rubber casing !
the drawing of the clip is above !
should i just put it around the groove and put it 2 ends on each other and then insert it with the clip into the hole ! i am afraid it could fall in !
MIKE
3geez member since October 4th 2001
accord_lx_86 just mailed me the pic of the clip ! but how the hell should i put it on !
i looked at the wire and here is a pic of it !
# 1 is the wire it self
# 2 is a groove
# 3 is a rubber casing !
the drawing of the clip is above !
should i just put it around the groove and put it 2 ends on each other and then insert it with the clip into the hole ! i am afraid it could fall in !
MIKE
3geez member since October 4th 2001
Posting Permissions
Reply With Quote
Bookmarks