I have not personally used this style of well nut to mount any thing on a car before but i heres how i would do it. You would to lay blue tape on the out side of the lid and outline the duckbill. You would want to make a small dimple from the bottom side so the you can see where the hole should be drilled in the lid. Once you have done this you can drill the holes in the trunk lid. Next tape the duck bill to the lid and from the bottom of the lid with a sharpie holding the duckbill as still as possible and mark where the holes in the duckbill go. This is the most important step because the better you line things up the better the fitment will be edge to edge. Then you drill holes in the duckbill. They are maybe a 1/4 inch deep probably less so when doing so you willing just and the tip of the bit poke though. From there its just install the well nuts and bolting them to the lid.
Sent from my SM-N920P using Tapatalk
Bookmarks