http://www.bsawheels.com.au/users/Pr...il.aspx?id=106
Sorry to frustrate those on 4x120 but I just bought a cheap set of 2nd hand 4x100 alloys for mine... & hopefully I won't regret it, since they apparently come courtesy of a customised GM/Holden/Izuzu Gemini, AKA Chevette/Kaddet that met its end. So I still have to get them checked out to make sure none are bent etc.
It is a delicate design more commonly seen in rediculous 16"/17" sizes on cheap Mitsubishi Lancers or Civics to show-off their weedy brake drums... But since my 'cord now has 4 whl discs...I won't have to remove the wheels to check my brake pads, though I'll have to repaint them now!
They're 14"x6" so not too big (I admit I'd prefer 15") with a 38mm offset & will need refinishing since they've been kerbed -& their spoke design protrudes past the rim to make it more obvious.
& I have to get different wheel nuts & center-hole adaptors & tyre valves before I can fit them properly.
Too RICE ?
They're missing their center caps so I'll probably leave the wheel nuts exposed.
Any colour/finish suggestions welcome more pictures to follow...
Bookmarks