Tunning A Weber 32/36

[SILENT]

Hey I have emmisions due... But i have a feeling the with all the emission controls i removed i wont pass emissions. I read on some post the a member would tune his weber and pass emissions... i forget which member it was... but basically need help!!!

[turabaka]

I ended up having to do that to pass emissions. All I did was drive it to the testing place with it tuned normally, then in the parking lot I turned the air/fuel screws all the way in. Got in line, tested it, then turned them back to normal as soon as I finished. Hopefully you pass doing that. I think my test results were like .001 on CO and like 2 on HC. I can't remember what it was at 2500 rpms though. Something pretty close to that I think.

[SILENT]

do you have a pic where u could point those out for me i really dont know much about my weber... i had a friend that was a carb expert and he would adjust my carb... i honestly dont know how to!!! i lost the paper that came with the kit also!!!!

[turabaka]

It's the two thumbscrews on the base of the carb. One's on the front, and the other is on the back. I'll try to find a pick, but I'm not sure I have one.

[SILENT]

ok i think i know which ones you are talking about... lemme get this str8 is left for lean and right for rich... or is it vise-versa???

[turabaka]

yes. turning the screws in tighter is leaner, and out is richer.

[SILENT]

thank you!!! i will try this and see!!! THank you again

[2oodoor]

keep in mind that was with a 38/38 which has two air mix screws, the 32/36 only has one